Install Baseboard Existing Carpet

The base shoe only adds 1 2.

Install baseboard existing carpet.

Hammer tack nails through these holes into the wall plate. The idea is that you should. This is generally about an inch for the nail tack and you will use a carpet tucker to tuck the excess carpet into the baseboard. When installing carpet after the baseboards are in place there will usually be some instructions that tell you how far you need for both the carpet pad and the carpet itself.

Coping an inside corner joint. The carpet installer can run the tack strip up to the trim then roll excess carpet under the trim. Once the trim is fastened remove the short baseboard pieces and move these along as you install the baseboard. Tools and supplies to install baseboards.

This is the basic method for baseboard installation for carpet applications. Installing a baseboard trim around carpet areas adds a fancy edge to the room helping to make the carpet part of the room. Preparing to install baseboards. When installing baseboards before carpet ask the installer how large of a gap to leave between the floor and the trim e g.

Baseboard installed on top of carpet should be installed at approximately the same height with this exception. If the molding is slightly long trim it at angled 1 16 inch increments from the end to fit the wall. These can be reused over and over again so hold onto them. Safety tips for installing baseboard.

Quarter round will stick out farther than necessary where the baseboard ends and door casing begins which is where the baseshoe should terminate either with a chamfered end or a returned mitered end. If you are not intending to install quarter round or base shoe the baseboard should. I would suggest installing the baseboard and then adding 1 2 x 3 4 base shoe not quarter round. Nail the baseboard in place with the sticks resting only lightly on the surface of the carpet.

All you need to so now is go along that wall and fasten the remainder of the trim as you normally would. Drill 1 16 inch holes every 16 inches through the baseboard angled downward toward the wall plate. Scarf and butt joints.