Install Vinyl Planks Click

Lower the second plank to snap the planks together.

Install vinyl planks click.

One of the evolutions of the do it yourself industry has been the creation of easy to use and easy to install products such as vinyl plank flooring. It comes in tiles and planks but this article covers planks only and uses a product called adura locksolid. When using tongue and groove planks vinyl flooring installation should start in a lefthand corner with the tongue facing the wall. To cut the last piece to fit score it with a utility knife and snap the plank.

Install one row at a time clicking the ends together. We are going to install a 7 5mm luxury vinyl click lock plank floor that comes with underlayment pad attached on the bottom of the planks. Vinyl plank flooring like laminate or wood flooring needs to have a layout that is pleasing to the eye. Position the first plank from the starting wall using inch spacers.

We need the level of the floor to be increased by approximately 1 16th of an inch to come up to the same level of the floors surrounding it. Installing click lock vinyl plank flooring trim the short tongue edge from the first vinyl plank. Plan the flooring layout. The procedure for installing glue together planks is virtually identical to that for installing click lock planks but instead of snapping the planks together you remove the backing from the glue strips butt the planks together and press down to seal the adhesive.

To trim planks use a utility knife and a straight. Install planks from the left side of the starting wall and work to the right side. Generally this is done by working from the most visible wall usually the one that greets the eye as you enter the room then working outward toward the entryway. Square the joints by tapping the long edge with the profiled tapping block and soft faced.

Install the second plank by holding it at an angle and inserting its tongue edge into the first plank s groove edge. To finish installing vinyl plank flooring replace the baseboards and add floor transitions and additional trim pieces like shoe molding if desired. If starting with a full width plank the tongue must be removed figure 3. Hold the next plank at a slight angle against the previous plank s end and fold down to click it into place.

Lay the first plank appropriately spaced from the wall. Snap a chalk line at the starting point to maintain alignment. It s a floating floor which means it isn t fastened to the subfloor it just lies there.